Linear Receiver Logic Board Required Soldering for Garage Door to Operate with Remote Control

 In blog

Linear Receiver Logic Board Required Soldering for Garage Door to Operate with Remote Control

Linear reciever terminals that has been soldered back to the logic board.

After soldering of logic board fixed the issue with the remote not working with the operator. This logic board is over 20 years old and has seen lots of vibration. This vibration over the years has cased the logic board pins to loose there solder hold/connection to the printed circuit board. The technician “Lenn” was able to soldier the pins back to the logic board to correct the issue where the remote signal was not being received properly.

Recommended Posts

Start typing and press Enter to search