Delta Garage Door Center Bearing Plate Fasteners Released Unexpectedly
You can see that there is a belt sagging from the picture. It is hard to tell right away that the center bearing plate let go. There is drywall damage that has been torn away roughly.
Closer view of the center bearing plate that as let go. This is extremely dangerous. If you see that there are fasteners that are not holding down your garage door properly. Then please call us right away at: 604-940-8918
During repairing of the garage door assembly. These fasteners are colored in red to let the homeowner know that they are serious and should not be adjusted.
You can see loose fasteners that are about to fall out. You can also see the backing that has cracked. There are wood shreds and plastic belt drive shavings all around the bearing plate. This is the evidence that the belt is in rough shape.
After repairs have been completed. You can see there is new backing that the technician repaired.
Repairs that are completed. You can see the trolley rail has been replaced with a full eight foot T-Bar that is all one piece. The belt is brand new and the garage door system is now ready for operation.
Proper Replacement of Liftmasters belt drive trolley rail. You can see that the belt has been properly adjusted and aligned. This trolley is a superiour piece of equipment that was originally installed.
You can see the belt that has been destroyed from a center bearing plate that has collided with the edge of the idler pulley.
Before repairs are made you can see the drywall damage and the belt all thrashed. This is a no go situation. You need to call us at 604-940-8918 to arrange repairs.
You can see the belt that excessive damage. If you see your belt has extreme sagging then there is a issue with your garage door that needs to be attended too.
extreme damage to the belt. This is not normal.
View of belt damage
Center bearing plate that is pushing up against the idler pulley. This is a situation that requires attention. Please do not try to repair this on your own.
Idler pulley damage from released fasteners. This damage is quite serious and needs attention. You can see the plastic shreds all spewed about.
Released center bearing plate that is holding onto the wall with just one fastener. You can see the backing that has been damaged beyond repair. This wood backing needs to be replaced before the spring assembly can be fastened to the wall without any worries.
Another angle of the center bearing plate / spring assembly that needs to be refastened to the wall.